Control panel message Description Recommended action
Resetting
factory settings
The printer is restoring factory settings. No action necessary.
Resetting
kit count
YES was selected in the Reset Supplies
menu to reset the counts for any of the
supplies that cannot be detected as new.
No action necessary.
Restoring
last saved state
The printer is restoring the last saved
state.
No action necessary.
Rotating <color>
cartridge motor
To exit press
Cancel Job key
A component test is in progress; the
component selected is <color>
Cartridge motor.
Press C
ANCEL
J
OB
when ready to stop this
test.
Rotating...
alienation motor
To exit press
Cancel Job key
The printer is executing a Component
Test and the component selected is
alienation motor.
Press C
ANCEL
J
OB
when ready to stop this
test.
Rotating...
belt drive
To exit press
Cancel Job key
The printer is executing a Component
Test and the component selected is Belt
Only.
Press C
ANCEL
J
OB
when ready to stop this
test.
Rotating...
fuser motor
To exit press
Cancel Job key
The printer is executing a Component
Test and the component selected is
fuser motor.
Press C
ANCEL
J
OB
when ready to stop this
test.
Rotating...
transfer motors
To exit press
Cancel Job key
The printer is executing a Component
Test and the component selected is
TRANSFER MOTORS.
Press C
ANCEL
J
OB
when ready to stop this
test.
Rotating
<color> Laser
To exit press
Cancel Job key
A Scanner Test is in progress. Press C
ANCEL
J
OB
when ready to stop this
test.
Saving current state The current state is being saved. No action necessary.
Setting saved A menu selection has been saved. No action necessary.
Test terminated A diagnostic test has been terminated by
pressing the C
ANCEL
J
OB
button.
No action necessary.
ENWW Control panel messages 129
