Control panel message Description Recommended action
EIO DISK X
NOT FUNCTIONAL
For help press
The EIO disk in slot X is not working
correctly.
Remove the EIO disk from the slot
indicated and replace with a new EIO
disk drive.
EIO DISK X
spinning up
The EIO disk device in slot X is spinning
up its platter.
No action necessary.
Event log empty SHOW EVENT LOG was selected from
the control panel, and the event log is
empty.
No action necessary.
FLASH DEVICE
FAILURE
alternates with
Ready
For menus press
A device failure has occurred on the
specified storage device.
1. Printing may continue for jobs that
do not require the Flash DIMM.
2. To remove this message from the
display, turn the printer off and then
back on.
3. If the message persists, remove and
re-install the Flash DIMM.
4. If the message persists, replace the
Flash DIMM.
Flash disk X
initializing
Do not power off
The new flash DIMM installed in slot X is
initializing.
No action necessary.
FLASH FILE
OPERATION FAILED
alternates with
Ready
For menus press
The printer received a PJL file system
command that attempted to perform an
illogical operation (for example, to
download a file to a non-existent
directory).
1. Printing may continue.
2. Turn the printer off and then back
on.
3. If the message reappears, there may
be a problem with the software
application.
FLASH FILE
SYSTEM IS FULL
alternates with
Ready
For menus press
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system is
full.
1. Use HP Web Jetadmin software to
delete files from the Flash Memory
and try again.
2. To remove this message from the
display, turn the printer off and then
back on.
FLASH IS
WRITE PROTECTED
alternates with
Ready
For menus press
The file system is protected and no new
files can be written to it.
1. To enable writing to the Flash
Memory, turn off write protection,
using HP Web Jetadmin.
2. To remove this message from the
display, turn the printer off and then
back on.
Genuine HP
supplies installed
A new HP cartridge has been installed.
The printer returns to the Ready state
after approximately 10 seconds.
No action necessary.
118 Chapter 8 Problemsolving ENWW
