33.21
Installing swinging arm
•
Slide swinging arm over drive shaft.
•
Lift drive shaft over the support surface in the
swinging fork and press forward swinging arm as
far as possible until gaiter snaps in position at the
gearbox neck.
•
Coat bearing pin of fixed bearing with
Optimoly TA and install and firmly tighten with
special tool
BMW No. 26 1 660.
•
Install bracket (1) for line of electric side stand
switch.
X Tightening torque:
Swinging arm fixed bearing ............................ 9 Nm
•
Coat bearing pin of loose bearing with
Optimoly TA, install, firmly tighten and secure
locknut.
X Tightening torques:
Bearing pin of loose bearing
(clean thread + Loctite 270)............................ 7 Nm
Locknut........................................................ 41 Nm
Installing footrest plates
•
Install left footrest plate.
•
[ABS] Note earth (ground) cable.
•
Mount silencer.
X Tightening torques:
Footrest plate to gearbox............................ 15 Nm
Silencer to footrest plate................................ 9 Nm
•
Install right footrest plate.
•
Carefully arrange all leads and hoses; ensure
they are not pinched.
•
[ABS] Note earth (ground) cable.
X Tightening torques:
Footrest plate to gearbox............................. 15 Nm
[ABS I] Support bracket,
pressure modulator...................................... 17 Nm
26 1 660
LT330310
LT330390
1
