Filter
Top Products
20
WARNING: Be familiar with all
controls and their proper operation.
Know how to stop the machine and
disengage them quickly.
Engaging the Augers
and Impeller
Power to the snow thrower attachment is activated by
engaging the tractor’s PTO.
1. Place the tractor’s throttle control in the FAST (rab-
bit) position and allow it to remain there for efficient
snow removal.
2. Move the PTO knob or PTO lever (on tractor’s so
equipped) into the “ON” position to engage the
augers and impeller.
3. Move the PTO knob or PTO lever (on tractor’s so
equipped) into the “OFF” position to disengage the
augers and impeller.
NOTE: The PTO knob (on units so equipped) cannot
be in the engaged (ON) position when the tractor is
driving in the reverse direction. The PTO knob must be
in the disengaged (OFF) position when the shift lever
is placed in REVERSE or the electric PTO clutch will
automatically shut off.
Refer to your tractor’s Operator’s Manual for more
information regarding your tractor’s PTO and safety
interlock system.
Lift Handle
The lift handle is located on the right side of the tractor
and is used to raise and lower the snow thrower
attachment.
1. To raise the snow thrower attachment off of the
ground, pull rearward and down on the lift handle
until you feel the lift latch on the right side of the
snow thrower engage, locking the snow thrower in a
raised position.
2. To lower the snow thrower, push downward on the
lift handle until there is enough slack in the lift cable
so that you may squeeze the trigger control. With
the trigger control squeezed, gently allow the snow
thrower to lower until it reaches the ground.
9
Controls
Chute Directional
Control
The chute directional control assembly is found on the left
side of the tractor and includes both the chute tilt lever as
well as the chute crank. Both affect the direction that the
discharged snow is thrown.
To pivot the upper section of discharge chute, affecting
the distance and angle which the snow is thrown, move
the chute tilt lever forward or rearward into a desired
position.
The direction which snow is thrown can be changed
by rotating the discharge chute with the chute crank.
Turn the chute crank clockwise to rotate the chute and
discharge snow to the left. Crank it counterclockwise to
rotate the chute and discharge snow to the right.
NOTE:
The PTO knob (on
units so equipped)
cannot be in the
engaged (ON) position
when the tractor is
driving in the reverse
direction. The PTO
knob must be in the
disengaged (OFF)
position when the
shift lever is placed
in REVERSE or the
electric PTO clutch
will automatically
shut off.
Be familiar with all
controls and their
proper operation.
Know how to stop
the machine and
disengage them
quickly.
WARNING