Filter
Top Products
About Link 1000 Settings
29
Advanced Function Values
The Link 1000 has sixteen advanced functions. The default
setting is appropriate for most, and you should not change a
value unless you understand the consequence of the change.
How to Enter Setup Mode and Change a Value: Reminder
The procedure for entering Setup mode and changing a value
is given on page 20.
F01 Auto Display Scanning
Default: Off
Range: Off, On
When Auto Display Scanning is On, the display
automatically scrolls through Volts, Amps, Ah, and Time
remaining. Each value is displayed for four seconds.
If Second Battery Voltage Sense (F11) is also on, two
voltages are shown. The flashing Volts status LED
indicates that the voltage displayed is that of the second
battery bank.
F02 Display Sleep
Default: On
Range: On, Off
This function turns off the Numeric Display and the Display
Units LEDs. All the other LEDs—
BATTERY STATUS light
bar,
AC IN, Charger status LEDs, CHARGE LED, and INVERT
LED—stay on.
Note: If you are monitoring more than one battery:
• Change Function F11, Second Battery Voltage Sense.
• Record the software revision number on page 60. (See “F15
Display Software Revision Number” on page 34.)