38 Assembly
MAN0943 (07/12/2011)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Do not allow bystanders in the area when oper-
ating, attaching, removing, assembling, or servic-
ing equipment.
Do not handle knives with bare hands. Careless
or improper handling may result in serious injury.
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
Check that all hardware is properly installed.
Always tighten to torque chart specifications
unless instructed otherwise in this manual.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy com-
ponents.
1. Open the crate and cartons containing the
attaching components and mounting hardware.
2. Use the packing list to check that all parts have
been shipped.
For Some Models Shipped on End
Units that stand on their aft ends during shipping have
a dipstick shipping plug installed in the gearbox dipstick
tube to prevent leakage during shipping.
NOTICE
■
For units shipped on aft end, the dipstick ship-
ping plug must be removed before shredder opera-
tion. Replace plug with dipstick in filler tube after
shredder has been removed from truck and leveled.
After the unit has been leveled for a couple of hours,
check oil level and service through the dipstick/filler
tube as required.
Figure 39. Dipstick Shipping Plug Removal
WHEEL ASSEMBLY
1. To get desired row spacing, measure from center
of frame and mark suspension mounting tubes.
2. Bolt strut uprights to shredder frame but do not
tighten at this time, Figure 40. See parts list pages
48 and 49 for hardware sizes.
Figure 40. Strut Uprights Installed
CAUTION