Filter
Top Products
Assembly
en
NOTES: All fasteners are in the parts bag. Do not dis-
card any parts or material until the unit is as
sembled.
Before doing any assembly or maintenance to the
mower, remove the wire from the spark plug.
Install the Seat
1. Carefully remove the plastic bag from the seat.
2. Raise the seat support (1) (see F
Figure 2
).
3. Align the holes in the seat (2) to the slots in the
seat support.
4. Install the seat (2) to the seat support (1) and
adjustment lever (3) with washers (4) and bolts (5).
NOTE: Install the washers on the left side only.
5. Connect the wiring harness (6) to the seat switch
(7) under the seat.
1
3
7
5
4
6
2
5
Figure 2
9
6. Lower the seat to the normal operating position.
7. Check the operation of the seat adjustment.
a. If the seat needs adjustment, raise the adjust-
ment lever (3) toward the seat and move the
seat to the desired position.
b. Release the adjustment lever to lock the seat
in place.
Install the Front Wheels
1. Make sure the valve stem (1) is to the outside (see
Figure 1
).
2. Slide the front wheel (2) onto the spindle (3).
3. Faster the front wheel (2) with washers (4 and 5),
and cotter pin (6) Bend the ends of the cotter pin
apart to keep the front wheel on the spindle.
4. If your model has hub caps (7), install the hub
caps. Make sure the washers hold the hub caps in
place.
5. Repeat for opposite side.
Figure 1
1
2
3
7
4
6
5