Filter
Top Products
19
Section 3: Options
3/18/15
SBL2566, SBL2574, & SBL2584 with S/N 891531+ Snow Blowers 370-478M
Table of Contents
Skid Steer Control Harness With 2 Eyelets
Refer to Figure 3-7:
370-134A Skid Steer Control Harness
This harness is used with skid steers not equipped with a
Deutsch HD30 14 pin or 2 pin coupler. It consist of the
following:
• Power cord (#3): Attaches to skid steer battery and
control box (#6).
• Control box (#6): Mounts in a convenient location for
operator to access from the seat. See also Figure 4-1
on page 20.
• Wire harness (#2): Attaches to control box (#6) and
runs from control box to rear of the loader arm.
• Wire harness (#1): Attaches to wire harness (#2) at the
rear of the loader arm and travels along the loader arm
to the front of the loader arm.
• Wiring harness (#4): Attaches to wire harness (#1) at
the loader arm and solenoids at the Snow Blower.
• Cable ties (#5): For securing wire harnesses
(#1, #2, #3, & #4) to the skid steer and Snow Blower.
• Installation Manual 370-349M: (not shown)
Outer Skid Shoes
Refer to Figure 3-9:
Outer skid shoes are mounted on the outside of the side
panels and are adjustable by unbolting them and
reattaching them at a different height.
370-451K SBL2566 SKID SHOE BUNDLE
370-438K SBL2574 & SBL2584 SKID SHOE
BUNDLE
Inner Skid Shoes
Refer to Figure 3-10:
Inner skid shoes are mounted behind the Snow Blower
and are adjustable vertically by pulling a bent pin and
moving the skid shoes up or down.
370-440K SKID SHOE BUNDLE
Toggle Switch Control Harness
Figure 3-7
2 EYLETS
CONNECTS TO 12V
POWER SOURCE
20 AMP FUSE
4 CONNECTORS THIS END
CONNECTS TO EQUIPMENT SOLENOIDS
35246
See Figure 4-1
on page 20.
Outer Skid Shoes
Figure 3-9
Inner Skid Shoes
Figure 3-10
37221
37222