Filter
Top Products
15
Section 3: Options
3/18/15
SBL2566, SBL2574, & SBL2584 with S/N 891531+ Snow Blowers 370-478M
Table of Contents
Motor Assembly
Refer to Figure 3-1:
MOTOR BUNDLE HYD 12-19 GPM . . . . . . . .370-253A
MOTOR BUNDLE HYD 20-26 GPM . . . . . . . .370-254A
MOTOR BUNDLE HYD 27-33 GPM . . . . . . . .370-255A
Three impeller motor assembly options are available to
meet your hydraulic flow requirements. They are
interchangeable and do not require adapter kits.
Compare your motor’s GPM rating located on an
attached decal with the GPM ratings above.
If your Snow Blower’s impeller motor is not compatible
with your skid steer or tractor, you should replace it with
one of the above assemblies that is compatible.
Flat Face Couplers
Refer to Figure 3-2:
The following flat face hydraulic couplers are available.
LARGE FLAT FACE COUPLERS . . . . . . . . .316-289A
Large flat face couplers consist of one large flat face male
coupler and one large flat face female coupler
SMALL FLAT FACE COUPLERS. . . . . . . . . .316-290A
Small flat face couplers consist of one small flat face
male coupler, one small flat face female coupler, and two
adapters.
Case Drain Coupler & Cable Ties
Refer to Figure 3-3:
CTL/SS COUPLER PACKAGE . . . . . . . . . . . 326-474A
When needed, order this optional 3/8” female quick
disconnect coupler for attaching to the Snow Blower’s
case drain line. Included with this package are three
cable ties for supporting the case drain line along its path
to the tank/sump.
Section 3: Options
Quick Release Couplers
Figure 3-2
Case Drain Coupler
Figure 3-3
37219
35808
Motor Assembly
Figure 3-1
37231
37223
Motor assembly for units with S/N- & below Motor assembly for units with S/N + & above