Filter
Top Products
17
Section 3: Options
3/18/15
SBL2566, SBL2574, & SBL2584 with S/N 891531+ Snow Blowers 370-478M
Table of Contents
Control Harness With Deutsch 2 Pin Plug
Refer to Figure 3-5:
370-434A Kubota CTL Skid Steer Control Harness
This harness is used with skid steers equipped with a
Deutsch 2 pin coupler but not the Deutsch HD30 14 pin
coupler. It consist of the following:
Refer to Figure 3-5:
• Power cord (#1): Attach Deutsch 2 pin plug (#1) to
Kubota’s CTL male plug (#7) located behind the
driver’s seat.
Refer to Figure 3-6:
• 10 amp Fuse (#8): Fuse (#8) is supplied by customer.
Install 10 amp fuse (#8) in Kubota’s fuse box slot #17
labeled “Electrical Outlet-2”.
Refer to Figure 3-5:
• Power cord (#1): Attaches opposite end of the power
cord (#1) to control box (#2).
• Control box (#2): Mounts in a convenient location for
the operator to access from the operator’s seat.
• Wire harness (#3): Attaches to control box (#2) and
runs from the control box to the loader arm.
• Wiring harness (#4): Attaches to wire harness (#3) at
the loader arm and at the solenoids on the Snow
Blower.
• Cable ties (#5): For securing wire harnesses
(#1, #3, & #4) to the skid steer and Snow Blower.
• Installation Manual 370-452M: Installation Manual, not
shown, is included with the Kit.
Kubota Power Connection (Located Behind Drive Seat)
Figure 3-5
Installation of 10 amp Fuse
Figure 3-6
37389
1
7
37390
8
Toggle Switch Control Harness For Kubota CTL Skid Steers
Figure 3-5
37145
See Figure 4-1
on page 20.