Filter
Top Products
14
Section 2: Equipment Hook-up & Unhook
3/18/15
SBL2566, SBL2574, & SBL2584 with S/N 891531+ Snow Blowers 370-478M
Table of Contents
Unhooking The Snow Blower
Refer to Figure 2-5:
1. See “Long Term Storage” on page 31 before
parking Snow Blower for long periods.
1. Park skid steer/tractor on a flat, level, solid surface,
and lower Snow Blower onto the surface.
2. Place transmission in park, set park brake, shut
power equipment off, and remove switch key.
3. With Snow Blower resting on the ground, release all
hydraulic system pressure before dismounting skid
steer or tractor. See Skid Steer Operator’s Manual for
instructions on how to release skid steer hydraulic
system pressure.
4. Disconnect solenoid wire harness (#4) from the front
of the loader arm. Do not disconnect harness from
the solenoids.
5. Disconnect hydraulic hoses (#1, #2, & #3) from skid
steer or tractor mounted hydraulic reservoir.
6. Store hydraulic hoses and wire harness on the Snow
Blower frame to keep dirt away from the couplings
and electrical connector.
7. Raise lock pins on loader hitch. If lock pins are
activated from the operator’s seat, return to the skid
steer/tractor to raise lock pins.
8. From the operator’s seat,
tilt top of loader hitch
slightly forward towards the Snow Blower.
9. Slowly lower skid steer/tractor hitch plate until top
angle bars and hitch plate have separated.
10. Back skid steer/tractor slowly away from the Snow
Blower while making sure it does not interfere with
the equipment.
Hook-up to Snow Blower
Figure 2-5
35599
Bottom slots
Top Angle Bars
1
2
3
5
4