Filter
Top Products
OPERATION
OM 0400-A
19
2
1
1
1
Figure 8a
Figure 8b
Figure 8c
GENERAL PREPARATION
1. Read the operator’s manual
carefully before using the tractor
and debris blower. Be thoroughly
familiar with the controls and proper
use of the equipment. Know how to
stop the unit and disengage the
controls quickly.
2. Make sure the impeller operates
freely.
3. Check the shear bolt on the PTO, for
proper tightness.
4. Wear adequate winter outer
garments while operating equipment.
ATTENTION
To avoid personal injury, be sure the
tractor engine is off, the drive shaft
disengaged, and all movement has
stopped before making any
adjustments.
Roadway Transport (Figures 8a-8b-8c)
1. Position the tractor and the debris blower on a level
surface.
2. Adjust the 3 point height to maximum.
3. Figure 8a: Go to the front of the debris blower at
approximate distance of 15 feet from it, in the middle
and at the same level than the tractor.
4. Figure 8b: Look toward the tractor and check if the
rear tractor lights are all visible, specially the lower
ones. (item 1). If some are hidden, lower the 3 point
until the lights become visible.
5. Figure 8c: When the height is set, take note of the
adjustment on the lever graduation (item 1) for futures
utilization with the same tractor. Then adjust the lock
(item 2) to the position found previously to make sure
to not exceed the prescribed height for security.
6. If you use another equipment and modify the lock
adjustment, make sure to reset the lock to the good
position to make the tractor lower rear lights always
visible.