Filter
Top Products
ASSEMBLY
OM 0400-A
11
Figure 1
A
TRACTOR PREPARATION
See Dealer for Tractor Preparation information.
DEBRIS BLOWER ASSEMBLY
Use the present manual and lay out all parts for assembly. Separate bolts and nuts into various sizes. After
assembly, torque all the bolts according to the Torque Specification Table at the end of the manual.
Debris Blower removing front wooden crate (Fig. 1)
1. Remove the six 3/8"NC x 3/4" carriage bolt
and six 3/8"NC serrated flange nut to
remove the belt protector (item 1).
2. Keep the hardware for further use. Remove
the four screws (item 4) and 1/4" flat
washers (item 5) that maintain the Debris
Blower to the crate.
3. Reinstall the belt protector (item 1) with the
six 3/8"NC x 3/4" carriage bolt and six
3/8"NC serrated flange nut removed
previously.
4. Remove the three round wire lock pins
(item 6) from the wheel support pins and
attach them in the holes provided on the
side of the Debris Blower (item A).
5. You may use the two lifting holes (item 7) to
move the Debris Blower more easily.