John Deere BL1130 Blower User Manual


 
ASSEMBLY
OM 0400-A
13
Installation of the Debris Blower
with a Quick Hitch Cat. 1
Figure 4: Place the Debris Blower (item 1) on
flat hard ground. Unlock the lower locks of the
quick hitch (item 2) by lifting the two hitch
levers. Back up the tractor slowly aligning the
three quick hitch hooks (item 4) with the three
bushings (item 3) of the debris blower and
lock the quick hitch lower locks.
IMPORTANT: To install on a Cat. 1 three
point hitch with a Quick Hitch, the pins with 1
1/2"OD bushings must be oriented toward
the inside. On a Cat. 2 quick hitch, they must
be oriented toward the outside.
Installation of the Debris Blower
with a Quick Hitch Cat. 2
1. Figure 5a: Remove the linchpins (item 1),
lockwashers (item 3), nuts (item 2) and pins
(item 4). Use a round wood stalk to block the
cat.1 and 2 pin during the loosening and the
tightening of the nut.
2. Figure 5b: Install the pins (item 1) in the
position illustrated and reinstall the
lockwashers (item 3), nuts (item 2), and
linchpins (item 4).
3. Figure 5c: Place the debris blower (item 1) on
flat hard ground. Unlock the lower locks of the
quick hitch (item 2) by lifting the two hitch
levers. Back up the tractor slowly aligning the
three quick hitch hooks (item 4) with the three
bushings (item 3) of the debris blower and lock
the quick hitch lower locks.
CATEGORY 2
Figure 5c
Figure 5a
Figure 5b
CATEGORY 1
Figure 4