Filter
Top Products
ASSEMBLY
OM 0400-A
16
SECTION TO CU
T
SECTION TO CUT
MARK OFF THE ZONE TO BE CUT ON BOTH HALVES
OPPOSITE EACH HALF-SHAFT GUARD
A
Figure B Figure C
NOTE:
Before cutting, make sure the two shafts
intersect by at least 7 3/4" when in working
position that is when the debris blower rests on
the ground.
3. Hold the two half-shaft side by side and
locate the "L" length between the two center-
to-center half-shaft universal joints. Mark off
the zone to be cut on both halves opposite
each half-shaft guard as shown on Figure B.
4. Cut off inner and outer guard tubes as well as
the inner and outer telescopic sections.
5. Cut the guard a second time leaving the
same distance between the end of the guard
and the end of the shaft as existed before.
To obtain the proper distance "A" shown on
Figure C, cut the guard according to the
following table:
DISTANCE A
Male PTO Female PTO
1 3/4" 1 1/4"
6. File down tubes and remove chips.
7. Apply grease to inside of outer telescopic
section.
IMPORTANT
: Work with fully guarded shafts
only!