Filter
Top Products
ASSEMBLY
OM 0400-A
17
Driveline Installation
(Figure 6)
1. Separate the debris blower from the three
point or quick hitch.
2. Grease driveline sliding surfaces and yoke
(item 1).
3. Remove the bolts (items 2) from the driveline
yoke ( (item 1) and connecter to the debris
blower shaft. Make sure the driveline is
well secured to the shaft by reinstalling the
bolts and nuts (item 2-3) in the order shown.
Tighten the bolts according to the Torque
Specification Table at the end of the manual.
4. Attach safety chain (item 4) around the upper
link to prevent the guard from spinning.
Figure 6