Filter
Top Products
7
1. From beneath the right running board, remove the
hex wash. hd. tapp screws and remove in the
following order: the reverse control pedal, forward
control pedal, and the brake pedal (See Figure 6).
NOTE: The following step 2 applies only to tractors
equipped with the Diff-Lock feature.
2. From beneath the left running board, remove the
retaining ring and hex wash. hd. tapp screw to re-
move the diff-lock pedal. Use care to avoid losing
the nylon bearing in the pedal (See Figure 7).
Figure 7
3. Raise the hood and remove the side panels per the
instructions in the tractor Operator’s Manual.
Figure 8
4. Loosen the four wing nuts securing the dash
screen to both sides of the bulkhead; then slide the
screen rearward and out from below the dash
panel (See Figures 8 and 9)
Figure 9
5. Remove the two hex screws securing the bottom
of the bulkhead and the front of the running board
to both sides of the frame (See Figure 8).
6. Carefully pull up the rear of the RH and LH foot
pads and remove the hex screws securing the
running board to the frame (See Figure 10).
Figure 10
7. From underneath the rear fender, turn the four tail
light sockets counterclockwise (approximately 1/4
turn) until aligned with the notches of the reflector
housing and pull the sockets from housings. Be
careful to avoid pulling the bulbs from the sockets.
8. Remove the cap from the fuel tank.
RETAINING
RING
DIFF - LOCK
PEDAL
HEX WASH. HD.
TAPP SCREW
NYLON
BEARING
WING
NUTS
HEX
SCREW
SCREEN
TABS
BULKHEAD
SLIDE SCREEN FROM
BELOW DASH PANEL
HEX SCREW
RH FOOT
PAD