Filter
Top Products
9
Veneto
™
Step 6. Twist the Pipe Assembly into the Motor
Adapter by turning Counter-Clockwise.
Step 7. Securely retighten the setscrew on the
Motor Adapter with the Allen Wrench.
CAUTION: The Motor Adapter has a special
coating on the threads. Do not remove this
coating; the coating prevents the downrod
from unscrewing. Once assembled, do not
remove the downrod.
Canopy
Decorative
Arm
Decorative
Scroll Screw
Scroll Bracket
Step 8. Insert one of the Scroll Screws through
the hole on one of the Decorative Scroll Arms and
screw into one of the holes on the Scroll Bracket.
Do not tighten.
Note: Ensure the Canopy is above the Scroll
Bracket before securing the Decorative Arms.
Step 9. Repeat until all 3 scroll arms are attached
to the Scroll Bracket.
Step 10. Place the Scroll Assembly on top of the
motor.
Step 11. Line up the Holes on the bottom of the 3
scroll pieces with the tabs on the top of the motor
and attach with the 3 scroll Assembly Screws. Do
not tighten.
Step 12. Adjust the Scroll Assembly until it is lined
up straight on the Pipe Ball and Fan Motor, then
Tighten all Screws, including the set screw on the
Scroll Bracket.
CAUTION: Failure to fully lock in the downrod
before securely tightening the allen set screw may
cause the fan to separate from the downrod during
normal operation!