Filter
Top Products
17
Direct - Touch
1 2
0
4 3
INSTALLING THE W74 WALL CONTROL
W-74 CONTROL INSTALLATION
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and
wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching
operations. For this reason the following precautions must be observed:
SINGLE W74 INSTALLATION
NOTE: W-74 Wall Control should only be installed on Casablanca's Direct-Touch
TM
Fans.
1. Use only the Casablanca W-74 wall control.
2. Do not use any additional control with your
Direct-Touch
TM
fan (for example, dimmer, or fan
speed control).
3. Do not use more than one fan per wall control.
4. No other light xtures or electrical appliances
may be connected on the circuit controlled by the
W-74 wall control.
W-74
Red
White
Blue
Black/White
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
NOTE: The RED wire is not used in this
application. DO NOT remove the crimped
cap from the wire.
BLACK AND WHITE
STRIPED WIRE
W-74
Wall Control
2 BLACK
WIRES
RED WIRE
NOT USED
8. Connect the green ground wire coming
from the back of the W-74 control to the
ground wire in the switch box. Secure
the splice with a wire nut.
9. Check your work by using the wiring
diagrams as shown in Figures # 1 and #2.
10. Install the W-74 in the wall box with the
two long screws provided.
11. Install the wall plate with the two white
screws.
1. If you have multiple Direct-Touch
TM
fans, refer to the
section "changing frequency setting" on page 20.
2. Remove the screws and switch plate from the existing
switch box.
3. Remove the screws holding the switch in the switch
box.
4. Pull the existing switch from the switch box to expose
the wire connections.
5. Remove the two wires from the switch.
6. Connect the BLACK wire from the POWER SOURCE
that you just removed from the switch to the BLACK/
WHITE STRIP wire on the W-74 wall control. Secure
this connection with a wire nut.
7. Connect the second BLACK wire that you just removed
from the switch to the second BLACK wire on the
located on the back of the W-74 wall control. Secure
this connection with a wire nut.
Figure 1
Figure 2