Filter
Top Products
10
UPPER GLASS HARDWARE
Upper Glass
Upper Bulb (6)
UPPER GLASS ASSEMBLY
Step 1. Slide the Glass over the upper part of the
Fan Assembly.
Step 2. The Glass should rest inside the rim of the
lower part of the motor on top of the foam strips to
avoid contact with rim.
Step 3. Remove each of the 6 Upper Bulbs from
their packs and Screw into the Bulb Sockets around
the top part of the fan.
Note: When replacing bulbs, only replace with max
15 watt bulbs.
Rim
HANGING THE FAN
Step 1. Trim wires to about 6" from the top of the
downrod.
Step 2. Strip 1/2" of insulation off each wire using
wire strippers. Raise the fan and place the ball into
the hanger bracket.
Step 3. Align the notch on the ball with the indent
in the hanger bracket. (Rotate the fan until you hear
the notch pop into place.)
Indention
Notch
WARNING: Fan may fall if
not assembled as directed
in these installation
instructions.