Filter
Top Products
19
Direct - Touch
1 2
0
4 3
OPERATION POWER
The
1 2
0
4 3
power button is normally left in the on position. Always turn the
power off during cleaning or servicing the fan and during thunderstorms. It
is also used to exit or enter additional programs.
The
1 2
0
4 3
power button must be left on to retain a previously set fan speed
or light level.
OPERATION SPEED CONTROL
There are ve individual speed settings for the fan. Each speed is
indicated by the number on the controller and an audible tone for
each speed.
To select the desired fan speed:
Press the number on the controller corresponding to the speed
desired. 4 is high, 3 medium, 2 low, 1 ultra-low, and 0 is off.
OPERATION REVERSING AIRFLOW
The direction of airow can be changed from downward to upward
or from upward to downward.
To reverse the airow:
1. Make sure the fan is on and blades are turning.
2. Press the
1 2
0
4 3
reverse button. You will hear a series of clicks
from the fan as it speeds up before coming to a stop and
changing direction.
To turn the lights off and on, press and release the
1 2
0
4 3
button for
either the up or down lights for less than one second.
To dim either the up or down light, Press and hold the
1 2
0
4 3
button
for either the up or down light for more than 1 second. The light will
come on at the last brightness setting and increase in brightness
until full power is reached, then start dimming until the lowest
setting is reached. This cycle will repeat until you release the light
button.
OPERATION LIGHTS
1 2
0
4 3
1 2
0
4 3
1 2
0
4 3
Note: It is normal for the fan
to start in the "High" position
from "Off" before changing to
the selected speed.
1 2
0
4 3
Up Light
Down Light
Note: The dimming feature
will only work as long as the
dimming feature remains
active. See "Operation CFL
mode".
W-74 OPERATION