Filter
Top Products
21
Direct - Touch
1 2
0
4 3
AUTOMATIC DEMONSTRATION PROGRAM
Programmed into every Direct-Touch fan is an Automatic Demonstration
Program. It can be used to fully demonstrate and test the operation of the
fan.
To enter the demonstration program:
1. Turn the
1 2
0
4 3
power button off for at least 5 seconds. This will clear
the fan memory ready for programming.
2. Turn the
1 2
0
4 3
power button on.
3. Immediately hold the "0" button for at least 5 seconds.
A multi-tone signal will verify the start of the test program. The fan and
lights will go through a series of changing fan speeds, reversing the fan
operation mode, turning off/on, and dimming the lights.
The complete cycle lasts slightly over one minute. It will continue to
repeat until the
1 2
0
4 3
is turned off for more than ve seconds, cancelling
the program.
OPERATION SAFEEXIT®
The Light-Minder Program automatically turns OFF the fan mounted lights after two
hours. To enter the Light-Minder Program:
1. To operate the lights for Light Minder Program – Turn the
1 2
0
4 3
power button off
for at least 5 seconds.
2. Turn the
1 2
0
4 3
on. Immediately press and hold the "1" button for 5 seconds. A
series of tones will be heard through the piezo-buzzer indicating the command
has been accepted. Once the lights turn on, they will automatically turn off after
2 hours.
3. Light operation still remains normal, if you leave the room and turn OFF the
lights, the lights will blink to indicate the Light Minder command has been
accepted. The lights will stay on for 2 hours and then begin to dim. After thirty seconds have elapsed,
the lights will turn completely off. In CFL Mode, the lights will not dim, but shut off after 2 hours.
4. To cancel the Light Minder Program, press the
1 2
0
4 3
power button and leave off for ve seconds.
The Safe-Exit Program gives you about thirty seconds of light when you turn the
lights off, enabling you to exit your home before the lights go out. To enter the Safe-
Exit Program:
1. Press the
1 2
0
4 3
power button off for at least ve seconds.
2. Turn the Power on. Immediately press and hold the "4" button for 5 seconds.
When a light button is pressed, an audio tone and series of lights blinking will indicate the program
is active. When CFL mode is disabled, the Lights will stay on at 50% brightness for 20 seconds then
decrease in intensity for 30 seconds then turn off.
3. With CFL mode active, the lights will turn off after 30 seconds.
4. To cancel the Safe-Exit Program, press the
1 2
0
4 3
power button and leave off for ve seconds.
Safe-Exit
Note: With CFL mode active,
the lights will not dim.
LIGHTMINDER® PROGRAM
Light-Minder