Filter
Top Products
16
Step 7. Remove the three lower bulbs from their
packaging, and install into the light kit.
Note: When replaceing bulbs, only replace with max
40 watt bulbs.
Step 8. Raise the Glass up to the Glass Adapter on
the bottom of the Light Kit.
Step 9. Slide the Glass Cover onto the bottom of the
glass
Step 10. Screw the Finial onto the bottom of the
Light Kit Stem to secure Light Kit.
Stem
Cover
Finial
Glass Adapter
W74 WALL CONTROL PREPARATION
Wall Plate
Screws (2)
Switch
Mounting
Screws (2)
(4) Wire Cap
WARNING!
To avoid possible electrical shock, make
certain that electricity is turned off at the
circuit breaker or fuse box before attempting
any installation or repair procedure
CAUTION! NOT turning the power OFF at the
circuit breaker or fuse box may cause damage
to the electronics within the wall control and or
the PC board on the fan.
W74 WALL CONTROL PREPARATION
Circuit Breaker
(Trip breaker for the
circuit you will be
working on)
Fuse Box
(Remove fuse for the
circuit you will be
working on)
W-74
Wall Control
Cover Plate