Filter
Top Products
Selecting a Preset Power Level Sweep Range
There are five preset power level sweep range pa
-
rameters selectable in the power level sweep modes.
These preset power level sweep range parameters
are L1-L2, L3-L4, L5-L6, L7-L8, and L9-L0.
To select one of the preset power level sweep ranges
from a Level Sweep menu, press the main menu key
LEVEL
CONTROL
The Level Sweep Control Menu (below) is displayed.
In addition to letting you select one of the preset
sweep ranges for the power level sweep, this menu
lets you select logarithmic or linear power level
sweep and set the start and stop power level pa-
rameters for each preset sweep range.
Setting a Preset Power Level Sweep Range–At
the Level Sweep Control menu, select the power
level sweep range (L1-L2, L3-L4, L5-L6, L7-L8,or
L9-L0) that you wish to set. The menu then displays
the current power level parameters for the selected
power level sweep range. Now, use the menu edit
soft-keys to open the power level parameters for ed
-
iting.
Edit the current power level parameter values or
enter new power level parameter values for the
power level sweep range. To close the open power
level parameter when you are finished, press its
menu edit soft-key or make another menu selection.
Selecting Type of Power Level Sweep–Press
Log/Linear to select logarithmic or linear power
level sweep. When Log is selected, power levels are
in dBm; when Linear is selected, power levels are in
mV. The soft-key label is highlighted (in reverse
video) to reflect your selection.
681XXC OM 3-57
LOCAL (FRONT POWER LEVEL
PANEL) OPERATION SWEEP OPERATION