Filter
Top Products
18
T. To Replace Basket (tumbler) or Basket (tumbler) Support
1. Discontinue power to the dryer.
2. Remove the lint drawer, and the control and lint door from the dryer. Follow lint drawer, and the control and lint
door removal procedures in section A and B.
3. If lower basket (tumbler) is being serviced, proceed to step 4 slide the control box out three quarters of the
way and disconnect the three (3) wire harness connectors located at the back of the control box, then remove
control box from the dryer.
4. Remove front panel from the basket (tumbler) being serviced. Follow front panel removal procedure in
section E.
5. Remove belt from dryer. Follow belt removal procedure in section H.
6. Remove both (upper and lower) halves of the rear split back guard panels to either the top or bottom basket
(tumbler), depending on which basket is being serviced.