Filter
Top Products
8
7. Reverse procedure for reinstalling power to the dryer.
IMPORTANT: When reinstalling the sensor bracket assembly to the dryer, be sure the internal wires do
not get pinched between the sensor bracket and the holder.
8. Reestablish power to the dryer.
H. To Remove or Replace Belt
1. Discontinue power to the dryer.
2. Remove the lint drawer and the control and lint door from dryer.
3. If top basket (tumbler) is being serviced, remove control box assembly and belt guard from idler arm. Follow
control box remove procedure in sections A and B.
4. Remove panel from basket (tumbler) being serviced. Follow from panel removal procedure in section E.
5. Loosen the tension on the idler arm adjusting spring by loosening the two (2) 9/16" nuts on the spade bolt.
6. Remove the motor pulley from the shaft. This can be done by rolling the fan belt off the pulley. Then loosen
the set screw of the motor pulley and slide the pulley off the shaft.
7. Slide belt off the idler bracket and motor shaft.
8. Push belt up into basket (tumbler) area through the brushes and opening in the wrapper.
9. Remove the belt by maneuvering it back and forth and sliding it forward with your hands up through the lint
drawer area.
10. The belt will come out from the front of the dryer between the basket (tumbler) and the wrapper.
11. Reverse procedure for installing new belt.
IMPORTANT: Be sure to set proper belt tension at idler adjustment. Follow belt and idler tension adjust-
ment procedure in section K.
12. Reestablish power to the dryer.