Filter
Top Products
9
LOCTITE
LOCTITE® is being used on ALL small dryers (AD-15 through 81 including stack dryers) that are manufactured
by ADC. LOCTITE® is being applied to ALL bearing set screws, used on ALL basket (tumbler) shafts, ALL
idler shafts, ALL impeller (fan and blower) shafts, and ALL drive shaft bearings.
IMPORTANT
LOCTITE® ADHESIVE HAS BEEN USED
TO SECURE SET SCREWS AND BEARINGS
IN PLACE, ONCE SET SCREWS HAVE BEEN
REMOVED, A GEAR PULLER MAY BE NECESSARY
TO REMOVE BEARING TO AVOID DAMAGE.
P/N 112801
®
One (1) of these labels is attached to each Basket (tumbler) Bearing Assembly (pillow block bearing box). On
the ADG-630 dryer this label is affixed near the small Impeller (fan) Shaft Bearing.
Should readjustments or removal of set screws become necessary in the field and the process becomes difficult,
apply heat to the set screw with a soldering gun (450º F) for a few minutes.
IMPORTANT: Readjustment and removal of the Impellor (fan) Shaft bearings using
Green LOCTITE® (#609) require that the bearing itself be heated.
In lieu of heating, ADC recommends the replacement of these assemblies
in order to provide a true fit and avoid any warpage upon reinstallation.
NOTE: The application of LOCTITE® during the dryer manufacturing process
does not preclude the recommended six (6) month interval that ADC
advises for periodically checking ALL set screws within the dryer.