Chapter 24 Configuration: Multicast
GS1900 Series User’s Guide
138
24.2.4 The Router Port Screen
Use this screen to view the Router Port settings. Click Configuration > Multicast > IGMP >
Router Port to open this screen.
Figure 119 Configuration > Multicast > IGMP > Router Port
The following table describes the labels in this screen.
24.2.5 The Add/Edit Router Port Screen
Use this screen to configure the Router Port settings. Click Configuration > Multicast > IGMP
> Router Port > Add/Modify to open this screen.
Last Member Query
Count Enter the number of queries.
Interval (sec) Enter the amount of time (in seconds) between the IGMP group-specific queries sent by an
upstream port when an IGMP Done message is received.
Querier
IGMP Querier
State
Select the IGMP querier status to Enable or Disable the function.
IGMP Querier
Version
Select the IGMP Querier version to v2 or v3.
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.
Table 100 Configuration > Multicast > IGMP > VLAN > Modify (continued)
LABEL DESCRIPTION
Table 101 Configuration > Multicast > IGMP > Router Port
LABEL DESCRIPTION
Router Port
Add Click Add to create a new Router Port entry.
VLAN ID Displays the ID of a static VLAN; the valid range is between 1 and 4094.
Static Router
Ports
Displays the ports that are defined as static router ports.
Forbidden
Router Ports
Displays the ports that are defined as forbidden router ports.
Modify
Edit Click Edit to make changes to the entry.
Delete Click Delete to remove the entry.
