3 - DIRECT-TO
62
190-00357-00 Rev C
Direct-to Shortcuts
Shortcuts
Shortcuts are available when using the direct-to
key, allowing you to bypass the use of the small and
large right knobs to enter the destination waypoint’s
identifier. A direct-to can be performed from any page
displaying a single waypoint identifier (such as the
WPT pages for airports and navaids) by simply press-
ing direct-to and ENT. For pages that display a list of
waypoints (e.g., the Nearest Airport Page), you must
highlight the desired waypoint with the cursor before
pressing the direct-to key.
When a single waypoint is displayed
on-screen, select it as your destination by
pressing direct-to. When a list of waypoints is
displayed, press the small right knob to dis-
play a cursor, highlight the desired waypoint,
then press direct-to.
To select an on-screen waypoint as a direct-to
destination:
1. If a single airport, navaid or user waypoint is
displayed on-screen, press direct-to, then press
ENT twice.
2. If a list of waypoints is displayed on-screen, press
the small right knob to activate the cursor, turn
the large right knob to highlight the desired
waypoint, then press direct-to followed by
ENT twice.
Direct-todestinationsmayalsobeselectedfrom
the Map Page by panning to the desired destination
location and pressing direct-to and ENT (twice). If no
airport, navaid or user waypoint exists at the desired
location, a waypoint named “+MAP” is automatically
created at the location of the panning pointer.
To select a direct-to destination from the map
page:
1. From the Map Page, press the small right
knob to display a panning pointer.
2. Turn the small and large right knobs to place
the panning pointer at the desired destination
location.
Use the panning pointer to select your desti-
nation directly from the map.
3. If the panning pointer is placed on an existing
airport, navaid or user waypoint, the waypoint
name is highlighted. Press direct-to and ENT
twice to navigate to the waypoint.
4. If the panning pointer is placed on an open
location, press direct-to and ENT twice to
create a “MAP” waypoint and navigate to it.
