9 - AUX PAGES
182
190-00357-00 Rev C
To set the arrival alarm and alarm distance:
1. Select “CDI / Alarms” from the Setup Page.
2. Turn the large right knob to highlight the
“On”/”Off” field (left-hand side of the field
directly below “Arrival Alarm”).
3. Turn the small right knob to select “On” or
“Off”, as desired. Press ENT to accept the
selection.
4. The flashing cursor moves to the alarm dis-
tance field (to the immediate right of “On” or
“Off”). To enter an arrival alarm distance, use
the small and large right knobs to enter
the desired alarm distance. Press ENT when
finished.
Units / Position
To set the magnetic variation:
1. Select “Units / Position” from the Setup
Page.
2. The flashing cursor highlights the heading
mode field. Turn the small right knob to
select the desired heading mode: Auto or
True. Press ENT to accept the selection. (The
heading modes are described previously in the
Units/Position section.)
To change the units of measure:
1. Select “Units / Position” from the Setup
Page.
2. Turn the large right knob to highlight the
desired units of measure category. The fol-
lowing categories, and corresponding units of
measure, are available:
•DIS, SPD — distance and speed in Nautical
(nautical miles/knots), Statute (miles/miles
per hour) or Metric (kilometers/kilometers per
hour) terms.
•ALT, VS — altitude and vertical speed in Feet/
feet per minute, Meters/meters per minute, or
Meters/meters per second.
•PRESSURE — barometric pressure in Inches
or Millibars.
•TEMP — temperature in degrees Celsius or
Fahrenheit.
•FUEL — fuel units in Gallons, Imperial Gal-
lons, Kilograms, Liters or Pounds.
3. Turn the small right knob to select the desired
units of measure for the selected category.
Press ENT to accept the selection.
Setup 1 Page
