Filter
Top Products
Maintenance Section 4-16
MAINTENANCE
ADJUSTING / CHECKING BELT TENSION
To adjust belt tension or replace belts on flail cutter head, remove four bolts that
secure belt cover and remove cover. The hex nuts shown below can be adjusted to
increase / decrease the belt tension as needed. (NOTE: Location of adjustment nuts
may vary on flail cutter heads.) Be sure to replace the belt cover BEFORE
operating mower!
DECK STOP ADJUSTMENT
Loosen locking nut. Turn adjustment bolt in, and run deck cylinder out to full
extension. Adjust bolt out until the head just touches the boom, and tighten lock nut.
NOTE: Bolt should not hit boom before cylinder reaches full travel.