Filter
Top Products
Assembly Section 2-5
ASSEMBLY
WEATHER-PACK/METRI-PACK ASSEMBLY
These instructions apply to both Weather-Pack and Metri-pack connectors.
NOTE: Use the specific tool for the type of connector you are assembling.
1. Apply seal to cable, before stripping
insulation.
2. Align seal with cable insulation.
3. Put terminal in crimping tool, then
position wire and seal in place.
4. Crimp and visually inspect for a good
crimp before installing in connector body.
INSTALLING O-RING FITTINGS
Installing straight, 45° and 90° O-rings requires that the O-ring and washer be up
against the swivel body. Insert the swivel and turn in until the swivel is pointed in the
desired direction and O-ring contact is made. Hold swivel in set direction with a wrench
and turn the O-ring nut away from the swivel body and carefully tighten.