Filter
Top Products
Bengal Brute Common Section 6 - 68
CLEAN CUTTER BLADE MOUNTING
The CLEAN CUTTER blade was designed for installation onto a standard
TRB50 spindle. It is equipped with replaceable carbide tipped teeth. Carbide is very
hard, it will chip or break on inpact. Handle the saw blade with care. DO NOT roll
saw on any hard surface or allow it to strike a hard object. Set it down on a piece of
belting or wood to avoid damaging carbide tips. Install two temperary(2) threaded
studs into (2) opposite holes in the spindle. Align the bolt holes in adapter (part
number 33875) with the studs and slide adapter over studs, be sure to index adaper
so as the protruding 2 7/8” diameter pilot on the adapter faces outward away from
spindle. Then slide the saw blade (part number 33874) over the studs and onto the 2
7/8” diameter pilot of the adapter. NOTE: Orient blade for clockwise rotation (blade
rotates clockwise when looking down on top of mower deck). Then slide the collar
(part number 33876) over the studs with the chamfered edge of collar to the outside,
be sure the counterbore bolt holes face outward. Apply Loctite “271” to the threads of
the 5/8-18 x 3” UNF Grade 8 bolts (part number 33877), and install lock washers (part
number 21992) onto the bolts, then install bolts through collar, blade, and adapter into
the spindle. Remove the threaded studs, and replace with bolts and lockwashers.
Torque bolts in an alternating pattern to 184 Ft-lbs.
ASSEMBLY - CLEAN CUTTER
Failure to follow the following warnings and instructions may
result in serious injury or damage to the equipment or
property!
WARNING: The blade alone weighs approximately 145 lbs. Be
sure its weight can be supported before attempting to replace.
The use of a lift mechanism will ease replacement.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked
up to prevent sudden or inadvertent falling which could cause
serious injury or even death. (SG-14)
DANGER!