Filter
Top Products
Assembly Section 2-7
ASSEMBLY
MAIN FRAME INSTALLATION
With an overhead hoist and / or jack-stands, raise one side of the frame up to the
correctly matching mounting holes. Install capscrews and all other hardware as shown
in main frame parts section to secure the sides of the main frame to the tractor casting,
DO NOT tighten at this time. Remove the capscrews one at a time and apply a thread
locking agent. Reinsert the capscrews and tighten / torque to values noted in the torque
chart located in the maintenance section of this manual.
VALVE MOUNTING PLATE
Align the mounting bracket to the existing holes on top of the tractor remote valve at
the rear of the tractor. Secure the bracket to the tractor with the hardware shown in the
parts section of the manual. Attach the valve mounting plate to the valve mounting
bracket on the rear of the tractor as shown below. Then place and secure the lift valve
on top of the valve plate, in the position shown in the parts section. Install the control
cables to the valve and route the hydraulic lines from the lift valve to the hydraulic cylinders
as noted on the lift valve page of the parts section.
HUSCO
VALVE
DANFOSS
VALVE