Filter
Top Products
Assembly Section 2-13
ASSEMBLY
JOYSTICK MOUNTING
The joystick control will require that the right armrest be modified and an additional
bracket attached that will accommodate the joystick. In doing this, the armrest must be
removed by sliding off the plastic cover and removing the capscrew from the lower right
side of the seat. After the capscrew is removed the armrest should be loose from the
seat and able to be removed at this point. Once the armrest is removed, then place the
joystick holder under the armrest, so that the indentation on the outside of the armrest is
lined up with the hole in the armrest bracket for the capscrew to pass through. Once
the correct placement is achieved, then mark on the armrest where the hole passes
through the armrest bracket. At this point a 1/2” hole must be drill through the armrest
so that the bracket can be secured to the armrest. After the hole is drilled, then on the
inside of the armrest the 1/2” hole must be cut to a larger diameter up to the metal plate
in the armrest so that a spacer and hex nut can be fastened to the capscrew that
secures the armrest bracket. Install the armrest bracket on the armrest with the
hardware as shown in the parts section.
Once the bracket is installed on the armrest then reattach the armrest back onto the
seat using the existing hardware previously removed. Then install the joystick in the
bracket with the machine screws as shown in the parts section.