Filter
Top Products
Assembly Section 2-2
ASSEMBLY
Before attempting to mount your Tiger mower, it is
important to read an understand all of the Safety Messages
in the Safety section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower received!
Always use a floor jack, hoist or fork lift to lift and raise heavy parts.
Read and understand the entire assembly section instructions before attempting to
mount your Tiger mower. Refer to the parts section of this manual for detailed illustrations
to locate all parts.
TRACTOR PREPARATION
A: Remove right hand steps.
B: Disconnect battery cables from both batteries.
C: Remove engine side panels, or raise hood to access front pulley.
D: Remove plugs from tractor casting where main frame and pump
mount will be attached.
E: Remove any front weights and weight supports.
F: Raise the tractor onto jack-stands and remove the right rear wheel.
CRANKSHAFT ADAPTER
If necessary remove the four capscrews from the crankshaft pulley. Then install the
crankshaft adapter to the pulley with capscrews and lockwashers as shown in the parts
section.