Filter
Top Products
Assembly Section 2-6
ASSEMBLY
POLYCARBONATE SAFETY WINDOW
NOTE: Installing a boom mower requires that all of the right side windows be
replaced, or protected with a polycarbonate window. This should be done before
mounting the main frame.
1. Disconnect gas shock at door. Remove the right side cab door/window glass
from tractor cab by removing hinge pins. Also, remove rear right side window.
2. Remove the existing hardware and discard factory glass door and window.
3. Place small beed of adhesive seal in the botom of the trim lock bubble beed.
4. Install trim lock bubble seal on polycarbonate starting at the center bottom
horizontal portion.
5. Install existing hardware removed from glass door and window on the
polycarbonate.
6. Install the polycarbonate assembly in the cab with existing and supplied
hardware.
7. Place the retaining brackets on the upper front and lower front of the cab
door/window with the 8mm capscrews.
8. Place the third bracket at the bottom of the door by the fender as shown in the
illustration below. Hold the bracket in place and mark the door jam.
9. Drill 21/64” hole in the door jam for the 5/16” capscrew and mount the bracket.
10. Install the right rear poly window into place where factory window was removed.