Tektronix TDS 420A Sprinkler User Manual


 
Appendix D: Factory Initialization Settings
TDS Family Oscilloscope Programmer Manual
D–3
Table D–1: Factory Initialization Settings (Cont.)
Control Changed by Factory Init to
Display trigger bar style Short
Display trigger “T” On
Display variable persistence 500 ms
Edge trigger coupling DC
Edge trigger level 0.0 V
Edge trigger slope Rising
Edge trigger source Channel 1
GPIB parameters No change
Hardcopy Format
Layout
Palette
Port
Unchanged
Unchanged
Unchanged
Unchanged
Horizontal – delay time/division 50 ms
Horizontal – delay trigger position 50%
Horizontal – delay trigger record length 500 points (10 divs)
Horizontal – FastFrame TDS 500C & 700C: Off
Horizontal – FastFrame, frame count TDS 500C & 700C: 2
Horizontal – FastFrame, frame length 500
Horizontal – fit to screen Off
Horizontal – main time/division 500 ms
Horizontal – main trigger position 50%
Horizontal – main trigger record length 500 points (10 divs)
Horizontal – time base Main only
Limit template ±V Limit
±H Limit
40 mdiv
40 mdiv
Limit template destination Ref1
Limit template source Ch1
Limit test sources Ch1 compared to Ref1;
all others compared to none.
Limit testing Off
Limit testing – hardcopy if condition met Off
Limit testing – ring bell if condition met Off
Logic pattern trigger Ch4 (Ax2) input TDS 510A, 500C, 600B, & 700C:
X (do not care)
Logic state trigger Ch4 (Ax2) input TDS 510A, 500C, 600B, & 700C: Rising edge