Filter
Top Products
Command Descriptions
2–106
TDS Family Oscilloscope Programmer Manual
*DDT
Allows the user to specify a command or a list of commands that are executed
when the instrument receives a *TRG command or the GET GPIB interface
message. *DDT is just a special alias that *TRG uses.
Miscellaneous
ALIAS:DEFINE, *TRG
*DDT { <Block> | <QString> }
*DDT?
<QString>
*DDT
<Space>
?
<Block>
<Block> or <QString> is a complete sequence of program messages. The
messages can contain only valid commands that must be separated by semico-
lons and must follow all rules for concatenating commands (see page 2–4). The
sequence must be ≤80 characters. <Block> format is always returned as a query
response.
*DDT #0ACQUIRE:STATE RUN;BELL<EOI>
specifies that the acquisition system will be started and the bell rings each time a
*TRG command is sent.
DELEte:SETUp (No Query Form)
Removes stored setups from memory and initializes the location with the factory
default setup.
NOTE. The setup information cannot be recovered once it has been deleted.
Save and Recall
Group
Related Commands
Syntax
Arguments
Examples
Group