Filter
Top Products
Page 60
880 SERIES
22.2 Intelli-Sound Stereo Receiver Operation
1. Power On and Off
Press power button (1) once
to turn on stereo system.
Press a second time to turn
off.
2. Adjusting Volume
Press VOL up/down button
(3) to increase or decrease
volume. Current volume
setting is briey displayed
(0 to 45).
3. Mute
In Radio or AUX mode, press
mute button (7) once to mute
audio output (“MUTE” ashes
on display). To restore audio output, press button (7) a second time,
or press volume up or down button. In CDP, USB, NAND mode,
press button (7) to pause playback. Press again to resume playback.
4. Program Selection
Press MODE button (4) to cycle through available program sources
as follows: Radio --> CDP --> USB --> NAND --> IPOD --> AUX
--> Radio. If a source is unavailable (e.g.: No CD, USB or IPOD
inserted), that source will not appear on the display (17).
5. Adjusting DSP Level
Press EQ button (5) repeatedly until display reads “FLAT”. Then
press VOL up/down button (3) to select sound mode: Flat, Rock, Soft
Rock, Jazz, Classic, Dance, Pop, Soft, Hard, Party, Vocal, Hip-Hop,
Dialog, Bass Boost 1 to 3, Loudness 1 to 16, or Flat.
6. Adjusting Bass Level
Press EQ button (5) repeatedly until display reads “BAS”. Press VOL
up/down button (3) to choose desired setting. A display of “BASS 0”
indicates center, -1 to -7 indicates bass cut, and +1 to +7 indicates
bass boost.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
2
5
6
8
7
4
9
3
12
11
10
13
14
15
1
16
17