Filter
Top Products
Page 52
880 SERIES
PROBLEM PROCEDURE
Pump does not
operate and icon
does
Depress JETS Button.
1. If no sound is detected or if a buzzing sound
is detected, turn off power to the spa and
contact your authorized dealer or qualied
service technician.
2. If motor operates, but now water ows to jets:
a. Pump may not be properly primed. See
instructions below.
b. Contact your Sundance Spas dealer or
qualied service technician.
Pump Priming Instructions:
This method must be used for the jets pumps because these pumps
are not connected to the main lter system in any way.
1. Turn off the power to the spa.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector’s cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap nger tight, replace the handle, and turn the spa’s
power back on.
CAUTION: If freezing conditions exist and pump is not
operational, take measures to protect the system from freeze
damage. See Section titled “Winterizing”, page 46.
PROBLEM PROCEDURE
Poor jet acton
(See Figures
F-H, pages
23-25)
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty lter (pages 42-44).
Water is too hot 1. Reduce thermostat setting (page 21).
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed lter cycles
(page 37).