Filter
Top Products
Page 42
880 SERIES
13.0 Hot Tub Maintenance
Proper and regular maintenance of your hot tub will
help it retain its beauty and performance. Your authorized Sundance
Spas dealer can supply you with all the information, supplies, and
accessory products you will need to accomplish this.
WARNING: Risk of Injury. The suction ttings in this spa
are sized to match the specic water ow created by the
pump. If it is necessary to replace the suction ttings or
the pump, be sure that the ow rates are compatible.
Because of the risk of injury,
Never operate or use the spa if the lter, lter lid,
or skimmer assembly are broken or any part of the
skimmer assembly is missing. Please contact your
dealer or nearest service center for service.
Never replace a suction tting with one rated less than
the ow rate marked on the original suction tting.
•
•
13.1 Cleaning/Replacing the Filter Cartridge
A programmable “Change Filter” reminder icon ashes on the
control panel display after a specied number days to remind you
to perform routine maintenance on your lter system. This reminder
must be reset at each interval. Refer to Section 12.6 (page 41) for
additional information and programming details.
Your Sundance hot tub is equipped with a two-stage MicroClean Ultra
lter cartridge assembly under the lter lid (Figures F through H, pages
23-25). Debris is ltered by the lter/circulation pump drawing water
through the lter assembly 24 hours a day, 7 days a week (unless
programmed otherwise). To ensure optimum performance, clean the
outer pleated lter and center insert monthly. Then replace the center
insert every 6 months, or as needed thereafter. Refer to procedure below
for details.
All models include a suction cover lter (#6540-213) located
directly under the MicroClean Ultra lter cartridge assembly that
prevents debris from entering the hot tub plumbing when jets
pump 1 is running. This lter should be cleaned every 2 months.
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE REMOVING
THE MICROCLEAN ULTRA FILTER ASSEMBLY!