Filter
Top Products
Page 40
880 SERIES
When a programmed lter/heating cycle activates, the LCD screen
displays the following message:
At any time, you may check the programming of any economy mode
lter/heating cycle by rst pressing (CYCLE) button then moving
through the menu by pressing either (CYCLE) or (SELECT)
button. The programming is changed only by pressing (UP) or
(DOWN) buttons during this process.
12.3 Adjusting Time of Day
The Sentry control system remembers the time of day even in the event
of a prolonged power outage. However, it may occasionally be necessary
to reset the time of day. For example: if you are not in the Pacic Time
Zone you will want to reset the time for your own time zone. (The
system will automatically adjust to and from daylight savings time.) To
accomplish this, press (DISPLAY) , (MODE) , and (DISPLAY)
button within ve seconds each. A number representing the
hour will be displayed, followed by AM or PM. The hour will advance or
decrease each time the (UP) or (DOWN) button is pressed
within ve seconds. Then, press the (DISPLAY) button again
to display minutes. Adjust minutes as necessary by pressing the (UP)
or (DOWN) button. After 5 seconds, the display will return to
normal and save your settings.
12.4 Main Control Panel Lock
To help prevent unauthorized use of your hot tub, the Sentry controls
incorporate a unique panel locking system which disables the controls on
the panel.
• To Lock The Main Control Panel: Press (DISPLAY) ,
(MODE) , and (UP) buttons within five seconds
each. A padlock symbol will appear on the LCD screen.
With the panel locked, all components are disabled from manual
activation and the only settings that can be adjusted are the standard
and economy lter/heating modes and time of day. All automatic hot
tub functions will operate normally.
• To Unlock Main Control Panel: Press (DISPLAY) ,
(MODE) , and (DOWN) buttons within ve
seconds. The lock symbol will disappear. All buttons are now
active.
*Note: Number will vary
according to which lter
cycle is being programmed.
*Note: Number will vary
according to which lter
cycle is being programmed.
1*1*
LOCKEDLOCKED