Filter
Top Products
3
Danger
This symbol indicates the presence of dangerous voltage within and outside the product enclosure
that may constitute a risk of electric shock, serious injury or death to persons if proper precautions
are not followed.
Caution
This symbol alerts the user to the presence of hazards that may cause minor or moderate injury to
persons, damage to property or damage to the device itself, if proper precautions are not followed.
Consult this document whenever this symbol is used on the meter, to determine the nature of the
potential hazard and any actions which need to be taken.
Note
This symbol directs the user’s attention to important installation, operating and maintenance
instructions.
Installation Considerations
Installation and maintenance of the ION 8800 meter should only be performed by qualified, competent personnel
that have appropriate training and experience with high voltage and current devices. The meter must be installed in
accordance with all local and national electrical codes.
If this equipment is used in a manner not specified by the manufacturer, the protection from electric shock, fire, etc.
provided by this equipment may be impaired.
DANGER
Failure to observe the following instructions may result in severe injury or death.
During normal operation of the ION 8800 meter, hazardous voltages are present on its connector pins,
and throughout the connected potential transformer (PT), current transformer (CT), direct connect without
PTs, digital (status) input, control power and external I/O circuits. PT and CT secondary circuits are capable
of generating lethal voltages and currents with their primary circuit energized. Follow standard safety pre-
cautions while performing any installation or service work (i.e. removing PT fuses, shorting CT
secondaries, etc).
Do not use digital output devices for primary protection functions. These include applications where the
devices perform energy limiting functions or provide protection of people from injury. Do not use the ION
8800
in situations where failure of the devices can cause injury or death, or cause sufficient energy to be
released that can start a fire. The meter can be used for secondary protection functions.
The ION 8800 meter’s chassis ground must be properly connected to a good earth ground for safety, and
for the noise and surge protection circuitry to function correctly. Failure to do so will void the warranty, and
create a risk of electric shock, injury or death.
When installing the meter, all voltage paths (measurement voltage and all auxiliary circuits such as the
power supply and the tariff control voltage) must be fused according to applicable local safety standards.
CAUTION
Observe the following instructions, or permanent damage to the meter may occur.
The ION 8800 meter offers a range of hardware options that affect input ratings. The ION 8800 meter’s
serial number label lists all equipped options. Applying current levels incompatible with the current inputs
will permanently damage the meter. This document provides installation instructions applicable to each
hardware option.
Do not HIPOT/Dielectric test the digital (status) inputs, digital outputs, power supply terminals or commu-
nications terminals. Refer to the label on the ION 8800 meter for the maximum voltage level the device
can withstand.
Replacing the meter battery with the wrong type or voltage rating could result in damage to the meter. Use
only a lithium LiSOCl
2
battery with a rated voltage of 3.6 V, and the same construction as the original
battery, as a replacement.