Filter
Top Products
10-3 HOW TO REASSEMBLE
10-3-l FRONT COVER
Attach the front cover to the engine main bearing cover.
Match the faucet joint. and tighten the bolts.
89
x 18mm bolt . .1 PCS.
80 spring washer . 4 pcs.
Tightening torque 130 to 110 kg-m
NOTE: Make sure that the slits for cooling air are down.
10-3-Z ROTOR
1) Clean the tapered part of the engine output shaft and
the female tapered part of the rotor shaft of oil and
other forergn matter with waste cloth.
21 Install the rotor and tighten the through-bolt. (.See
Ftg. 10-17.)
Tighten the through-bolt by strikmg a box spanner
or socket wrench hard clockwise.
NOTE: The outside diameter and lamination thick-
ness of the rotor is shown in 5-2-2 ROTOR under
Paragraph
5-2 FUNCTIONS.
NOTE: The through-bolt is shaped as shown below.
Fig. 70-16
n
Fig. lo-17
I
Model d I ! 5
: 8mm
’ 222 mm
25 mm
RGX180
i 5..16 In.
’ 8.74 in.
/
0.98 in.
-
’
RGX240 8 mm
230 mm
25 mm
RGX240D I
5.‘16 in.
( 9.06 in.
0.98 In.
Table lo- 1
-47 -