Filter
Top Products
-
Order 1
Item Procedure
I
Remarks
Tool
-.
6 Stator i 1) Remove the stator.
, Sever hammer the wind- Plastic hammer or
Puil out the stator from the front cover
ings and leads.
(.-j screwdriver
by lightly tapping the outside of the
Be careful not to peel
core with a plastic hammer. (See Fig. lo- ’ stator steel sheets.
the
11.) If the stator does not come out.
I
insert a screwdrive betaeen the front
cover and stator. and twist it.
I
-
,
I 2) Separate the stator and rear- co\-er.
It is not necessary to
Separate the connector ar d wire.
separate the stator and
Push the terminal locks in the con-
rear corer except when re-
nector with a pin havmg a needle-like
placing the stator. rear
sharp point. and remove the terminals.
cover. or diode stack.
i
(See Fig. lo- 13.)
!
I
!
I
Fig. lo-13
-
.Fig, lo- 72
-45-