Filter
Top Products
5-2-11 REAR COVER
The rear cover is also an alumrnum die casting. and has a
faucet joint to hold the stator together w-ith the front cover.
It has bosses inside for holding the brushes, and slits for
taking cooling air in. The slits are so designed that htrman
fmgers will not go in.
5-2-12 RUBBER MOUNTS (RUBBER VIBRATION
ISOLATORS)
Rubber pads for controlling generator vibration and disloca-
tion. These are made of the most suitable rubber material
to optimum shape and hardness.
Models RGX180. RGX240. and RGXI4OD in particular
use diagonal support rubbers to reduce vibration.
5-2-13 PIPE FRAME
Fig. 5- 12
I
1
I
Fig. 5- 73
The
pipe frame consists of a pipe frame skeleton. side plates X and B and box stak-.
SIDE PLATE B