Filter
Top Products
Order /
item
Procedure
Remarks Tool
!
- Rotor ( 11 Pull out the through-bolt. Fit a box
If an air spanner is at-ail-
Hammer
spanner or socket wrench orer the
head of the through-bolt. strike it
hard <ounterclockwse with a ham-
mer to loosen. and remove the
through-bolt. ISee Fig. 10-1-l.)
100 bo:t . . 1 pze.
able, use it for easy- re-
Box spanner. or
moval.
socket wrench
I4m.m
I
I.2) Remove the rotor.
1 Sever strike the slip rings
Strike the rotor by the core with a plas-
! or windings.
tic hammer. and remob-e the rotor from
I
the engine taper shaft. If the roror does
not come out. change its angle and
I
strike it again. (See Fig. lo- 15.1
1
Fig. lo-14
Fig. lo- 75
I
Order
Item
Procedure
Remarks
Tool
--
8
t
Front cover
i 1 I Remove the front colder.
13mm bo.x spanner
Remove the bolts that fasten the en-
gine’s main bearing cover to the front
cover.
80 bolt 3 pis.
- 46 -