Filter
Top Products
1 Order 1
item 1
Procedure
Remarks , Tool
4
Brush holder
( 1) Remove the brush cover.
!
Remove the brush cover in the back of
the rear cover.
40 screw . 2 pcs.
I (2) Remove the brush holders.
(See Fig. 10-10.)
Disconnect the terminals wired to the
brushes before removing the brush
holders.
56 screw 2 pcs.
I
1 ( + j screwdriver
1 Be
sure to remove the
brush holders first be- !
cause if the rear cover 1s
removed from the gen-
erator without removing
the brush holders. the
I brushes will break.
5
Rear cover i 1) Loosen the cover bolts and remove
them
4~ bolt. 3 pcs.
1 Omm spanner or
!
I
box spanner
(2) Remove the stator cover.
i. -) screwdriver
Turn up the stator cover edge and
I
remove the stator cover.
I
,
’ t.31 Remove the rear cover.
(See Fig. 10-l 1.)
Lightly tap the rear cover with a
plastic hammer. and remove it.
The type that uses a con-
nectar does not permit
complete separation of
the stator and rear cover
because the connector
i cannot be pulled out of
the rear cover or grom-
met. In this case. simply ,
remove the rear cover
!
’ from the bearing.
Fig. lo- 70
Fig. 10-71
- 44 -