Filter
Top Products
17
THE AUTOSET CS2 SYSTEM
ENGLISH
!
CAUTION
• Be very careful not to allow water to enter the AUTOSET CS2 as this
could affect therapy and/or damage the device.
• Do not tip the HUMIDAIRE while it is connected to the AUTOSET CS2.
If water enters the A
UTOSET CS2 device, turn off the main power switch at the
back of the unit and unplug it from the power outlet. Return the unit to your
equipment supplier for checking.
• Set up the HUMIDAIRE and the AUTOSET CS2 unit so that the tubing to the mask
runs higher than the machines. This will prevent condensation build-up.
• If condensation appears in the mask, turn the humidifier settings down.
RESLINK™
The RESLINK™ is a device that records data onto a SmartMedia™ card during your
therapy. The card can be returned to your clinician so that they can observe your
progress and adjust flow generator parameters if necessary. The R
ESLINK connects to
the back of A
UTOSET CS2 as shown. For full details on using the RESLINK, please refer
to the ResLink User’s Manual.
ANTI-BACTERIAL FILTER
Your clinician may recommend that you use an anti-bacterial filter. A filter should be
placed in the air tubing between the mask and the flow generator. If using a humidifier,
place the filter between it and the flow generator (see Figure 10 below).
Typically, the filter should be replaced daily. Check the filter instructions for full details.
Whenever a filter is added, removed or replaced you must run the Air Circuit Learn
function (see “Learn Circuit” on page 26).
NOTE
Only hydrophobic anti-bacterial filters should be used with a
HUMIDAIRE 2i
or
HUMIDAIRE 2iC.
eng.book Page 17 Friday, November 3, 2006 2:43 PM